:-D cool, en root ça ne met pas d'erreur à la connexion!!
Par contre, je n'arrive pas à envoyer de fichier...
J'ai un fichier texte qui s'appelle test, et je l'envoie en faisant (dans Kermit) :
(/home/mat/) C-Kermit>send test
Alors il affiche ça:
C-Kermit 8.0.209, 17 Mar 2003, localhost.localdomain [192.168.1.103]
Current Directory: /home/mat
Communication Device: /dev/ttyS1
Communication Speed: 9600
Parity: none
RTT/Timeout: 08 / 08
File Type:
File Size:
Bytes So Far:
...10...20...30...40...50...60...70...80...90..100
Estimated Time Left: (unknown)
Transfer Rate, CPS: 0
Window Slots:
Packet Type: %
Packet Count: 1
Packet Length: 28
Error Count: 2
Last Error: (resend)
Last Message:
X to cancel file, Z to cancel group, <CR> to resend last packet,
E to send Error packet, ^C to quit immediately, ^L to refresh screen.
avec Error Count qui augmente tout le temps, puis il termine par ça:
*************************
SEND-class command failed.
Packets sent: 2
Retransmissions: 11
Timeouts: 12
Damaged packets: 0
Fatal Kermit Protocol Error: Too many retries
HINTS... If the preceding error message does not explain the failure:
. Did you start a Kermit receiver on the far end?
. Adjust the timeout method (see HELP SET SEND).
. Increase the retry limit (see HELP SET RETRY).
. Try it again with SET STREAMING OFF.
. Try it again with SET PARITY SPACE.
. As a last resort, give a ROBUST command and try again.
Also:
. Be sure the source file has read permission.
. Be sure the target directory has write permission.
(Use SET HINTS OFF to suppress hints.)
*************************
Je vais essayer de voir un peu dans les options de la calcu et de Kermit, mais si vous avez déjà une solution toute faite, faites-le moi savoir :-D
Merci!
