[root@voyager2 ~]# smartctl -s on /dev/hda
smartctl version 5.36 [i686-redhat-linux-gnu] Copyright (C) 2002-6 Bruce Allen
Home page is
http://smartmontools.sourceforge.net/
=== START OF ENABLE/DISABLE COMMANDS SECTION ===
SMART Enabled.
[root@voyager2 ~]# smartctl -H /dev/hda
smartctl version 5.36 [i686-redhat-linux-gnu] Copyright (C) 2002-6 Bruce Allen
Home page is
http://smartmontools.sourceforge.net/
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
[root@voyager2 ~]# smartctl -a /dev/hda
smartctl version 5.36 [i686-redhat-linux-gnu] Copyright (C) 2002-6 Bruce Allen
Home page is
http://smartmontools.sourceforge.net/
=== START OF INFORMATION SECTION ===
Device Model: TOSHIBA MK6026GAX
Serial Number: 15SO1032S
Firmware Version: PA203G
User Capacity: 60,011,642,880 bytes
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 6
ATA Standard is: Exact ATA specification draft version not indicated
Local Time is: Wed Apr 18 15:58:01 2007 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x80) Offline data collection activity
was never started.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 239) seconds.
Offline data collection
capabilities: (0x1b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
No Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 47) minutes.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
2 Throughput_Performance 0x0005 100 100 050 Pre-fail Offline - 0
3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 1400
4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 5436
5 Reallocated_Sector_Ct 0x0033 100 100 050 Pre-fail Always - 0
7 Seek_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 100 100 050 Pre-fail Offline - 0
9 Power_On_Hours 0x0032 080 080 000 Old_age Always - 8234
10 Spin_Retry_Count 0x0033 208 100 030 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 3097
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 198
193 Load_Cycle_Count 0x0032 059 059 000 Old_age Always - 411120
194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 45 (Lifetime Min/Max 8/59)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0
197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0
220 Disk_Shift 0x0002 100 100 000 Old_age Always - 118
222 Loaded_Hours 0x0032 083 083 000 Old_age Always - 6809
223 Load_Retry_Count 0x0032 100 100 000 Old_age Always - 0
224 Load_Friction 0x0022 100 100 000 Old_age Always - 0
226 Load-in_Time 0x0026 100 100 000 Old_age Always - 240
240 Head_Flying_Hours 0x0001 100 100 001 Pre-fail Offline - 0
SMART Error Log Version: 1
ATA Error Count: 93 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 93 occurred at disk power-on lifetime: 7336 hours (305 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 40 70 7b b7 e6 Error: UNC 64 sectors at LBA = 0x06b77b70 = 112687984
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 40 70 7b b7 e6 00 00:49:10.964 READ DMA
c8 00 48 68 7b b7 e6 00 00:49:04.009 READ DMA
c8 00 50 60 7b b7 e6 00 00:48:55.553 READ DMA
c8 00 58 58 7b b7 e6 00 00:48:47.090 READ DMA
c8 00 60 50 7b b7 e6 00 00:48:39.768 READ DMA
Error 92 occurred at disk power-on lifetime: 7336 hours (305 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 40 70 7b b7 e6 Error: UNC 64 sectors at LBA = 0x06b77b70 = 112687984
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 48 68 7b b7 e6 00 00:49:04.009 READ DMA
c8 00 50 60 7b b7 e6 00 00:48:55.553 READ DMA
c8 00 58 58 7b b7 e6 00 00:48:47.090 READ DMA
c8 00 60 50 7b b7 e6 00 00:48:39.768 READ DMA
c8 00 68 48 7b b7 e6 00 00:48:31.308 READ DMA
Error 91 occurred at disk power-on lifetime: 7336 hours (305 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 40 70 7b b7 e6 Error: UNC 64 sectors at LBA = 0x06b77b70 = 112687984
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 50 60 7b b7 e6 00 00:48:55.553 READ DMA
c8 00 58 58 7b b7 e6 00 00:48:47.090 READ DMA
c8 00 60 50 7b b7 e6 00 00:48:39.768 READ DMA
c8 00 68 48 7b b7 e6 00 00:48:31.308 READ DMA
c8 00 70 40 7b b7 e6 00 00:48:24.352 READ DMA
Error 90 occurred at disk power-on lifetime: 7336 hours (305 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 40 70 7b b7 e6 Error: UNC 64 sectors at LBA = 0x06b77b70 = 112687984
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 58 58 7b b7 e6 00 00:48:47.090 READ DMA
c8 00 60 50 7b b7 e6 00 00:48:39.768 READ DMA
c8 00 68 48 7b b7 e6 00 00:48:31.308 READ DMA
c8 00 70 40 7b b7 e6 00 00:48:24.352 READ DMA
c8 00 78 38 7b b7 e6 00 00:48:17.408 READ DMA
Error 89 occurred at disk power-on lifetime: 7336 hours (305 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 40 70 7b b7 e6 Error: UNC 64 sectors at LBA = 0x06b77b70 = 112687984
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 60 50 7b b7 e6 00 00:48:39.768 READ DMA
c8 00 68 48 7b b7 e6 00 00:48:31.308 READ DMA
c8 00 70 40 7b b7 e6 00 00:48:24.352 READ DMA
c8 00 78 38 7b b7 e6 00 00:48:17.408 READ DMA
c8 00 80 30 7b b7 e6 00 00:48:09.307 READ DMA
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
Device does not support Selective Self Tests/Logging
[root@voyager2 ~]#
