Merci d'avoir mis à jour les rpms. J'avance petit à petit, j'ai passé le problème d'avant, mais ça ne marche toujours pas. Je remet le résultat des commandes pour que tu puisses m'aider.
Je n'ai plus de message d'erreur quand je fais un service network restart. Maintenant j'essaie de me connecter à mon réseau sans fil, qui n'a pas de clé de cryptage. J'utilise la méthode manuelle qui marchait avec opensuse :
ifconfig ra0 down
iwconfig rao essid MonReseauWifi
ifconfig ra0 up
dhclient ra0
dmesg |grep rt
Scanning NUMA topology in Northbridge 24
ACPI: PM-Timer IO Port: 0x808
Allocating PCI resources starting at 50000000 (gap: 40000000:bf780000)
Checking aperture...
CPU 0: aperture @ dc000000 size 64 MB
SELinux: Starting in permissive mode
Linux Plug and Play Support v0.97 (c) Adam Belay
PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report
agpgart: Detected AGP bridge 0
agpgart: AGP aperture is 64M @ 0xdc000000
pnp: 00:08: ioport range 0x680-0x6ff has been reserved
pnp: 00:08: ioport range 0x290-0x297 has been reserved
Linux agpgart interface v0.101 (c) Dave Jones
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
hda: cache flushes supported
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
ACPI: (supports S0 S1 S3 S4 S5)
hub 1-0:1.0: 2 ports detected
hub 2-0:1.0: 2 ports detected
hub 3-0:1.0: 2 ports detected
hub 4-0:1.0: 2 ports detected
ehci_hcd 0000:00:10.4: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
hub 5-0:1.0: 8 ports detected
ATA: abnormal status 0x7F on port 0xB407
kjournald starting. Commit interval 5 seconds
rt2500 1.1.0 CVS CVS http://rt2x00.serialmonkey.com
kjournald starting. Commit interval 5 seconds
rt2500 EEPROM: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Channel
rt2500 EEPROM: 8 8 8 8 8 8 8 8 6 6 6 6 6 6 dBm Maximum
USB Mass Storage support registered.
modinfo /lib/modules/`uname -r`/extra/rt2500/rt2500.ko
filename: /lib/modules/2.6.18-1.2869.fc6/extra/rt2500/rt2500.ko
license: GPL
description: Ralink RT2500 802.11g WLAN driver 1.1.0 CVS CVS
author: http://rt2x00.serialmonkey.com
srcversion: 5CA1E91D06A2618318FDC29
alias: pci:v00001814d00000201sv*sd*bc*sc*i*
depends:
vermagic: 2.6.18-1.2869.fc6 SMP mod_unload gcc-4.1
parm: debug:Enable level: accepted values: 1 to switch debug on, 0 to switch debug off. (int)
parm: ifname:Network device name (default ra%d) (charp)
uname -a
Linux coruscant 2.6.18-1.2869.fc6 #1 SMP Wed Dec 20 14:51:34 EST 2006 x86_64 x86_64 x86_64 GNU/Linux
cat de /etc/modprobe.conf /etc/modprobe.d/rt*
alias eth0 skge
alias scsi_hostadapter sata_via
alias snd-card-0 snd-via82xx
options snd-card-0 index=0
options snd-via82xx index=0
remove snd-via82xx { /usr/sbin/alsactl store 0 >/dev/null 2>&1 || : ; }; /sbin/modprobe -r --ignore-remove snd-via82xx
# rt2500 Ralink wireless
alias ra0 rt2500pci
#options rt2500 autocreate=sta