Voilà ce que retournent toutes les commandes que vous m'avez demandé :
=== START OF INFORMATION SECTION ===
Device Model: Hitachi HTS545032B9SA00
Serial Number: 100830PBNC08EYJUM5PS
LU WWN Device Id: 5 000cca 61ee7d44c
Firmware Version: PB3OC60X
User Capacity: 320 072 933 376 bytes [320 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 5400 rpm
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: ATA8-ACS T13/1699-D revision 6
SATA Version is: SATA 2.6, 1.5 Gb/s
Local Time is: Thu Apr 2 16:00:49 2015 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 645) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 106) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 062 Pre-fail Always - 0
2 Throughput_Performance 0x0005 100 100 040 Pre-fail Offline - 0
3 Spin_Up_Time 0x0007 145 145 033 Pre-fail Always - 2
4 Start_Stop_Count 0x0012 098 098 000 Old_age Always - 3810
5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 100 100 040 Pre-fail Offline - 0
9 Power_On_Hours 0x0012 075 075 000 Old_age Always - 11049
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 098 098 000 Old_age Always - 3643
160 Unknown_Attribute 0x003b 100 100 001 Pre-fail Always - 3643
191 G-Sense_Error_Rate 0x000a 100 100 000 Old_age Always - 0
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 34
193 Load_Cycle_Count 0x0012 098 098 000 Old_age Always - 21356
194 Temperature_Celsius 0x0002 144 144 000 Old_age Always - 38 (Min/Max 13/46)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0
197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0
223 Load_Retry_Count 0x000a 100 100 000 Old_age Always - 0
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0
SMART Error Log Version: 1
No Errors Logged
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 11045 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
[nicryc@pc ~]$ systemctl status systemd-fsck-root.service
● systemd-fsck-root.service - File System Check on Root Device
Loaded: loaded (/usr/lib/systemd/system/systemd-fsck-root.service; static)
Active: active (exited) since jeu. 2015-04-02 11:53:44 CEST; 4h 9min ago
Docs: man:systemd-fsck-root.service(8)
Main PID: 481 (code=exited, status=0/SUCCESS)
CGroup: /system.slice/systemd-fsck-root.service
avril 02 11:53:17 oln systemd-fsck[481]: /dev/mapper/fedora-root: La date de…ur.
avril 02 11:53:17 oln systemd-fsck[481]: (de moins d'un jour, probablement à…GÉ.
avril 02 11:53:44 oln systemd-fsck[481]: /dev/mapper/fedora-root : 147816/32…ocs
Hint: Some lines were ellipsized, use -l to show in full.
[nicryc@pc ~]$ systemctl status systemd-udev-settle.service
● systemd-udev-settle.service - udev Wait for Complete Device Initialization
Loaded: loaded (/usr/lib/systemd/system/systemd-udev-settle.service; static)
Active: active (exited) since jeu. 2015-04-02 11:53:45 CEST; 4h 10min ago
Docs: man:udev(7)
man:systemd-udevd.service(8)
Main PID: 489 (code=exited, status=0/SUCCESS)
CGroup: /system.slice/systemd-udev-settle.service