En fait le pc est conecter sur internet par ethernet et j'aimerai mettre le pc en point d'acces pour ma psp et pour des pc qui sont equiper de wifi
lspci
00:00.0 Host bridge: VIA Technologies, Inc. VT8377 [KT400/KT600 AGP] Host Bridge (rev 80)
00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI Bridge
00:0d.0 Network controller: RaLink RT2561/RT61 rev B 802.11g
00:0f.0 IDE interface: VIA Technologies, Inc. VIA VT6420 SATA RAID Controller (rev 80)
00:0f.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.4 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 86)
00:11.0 ISA bridge: VIA Technologies, Inc. VT8237 ISA bridge [KT600/K8T800/K8T890 South]
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/8237 AC97 Audio Controller (rev 60)
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 78)
01:00.0 VGA compatible controller: nVidia Corporation NV18 [GeForce4 MX 4000 AGP 8x] (rev a4)
dmesg |grep rt
ACPI: PM-Timer IO Port: 0x4008
Allocating PCI resources starting at 20000000 (gap: 10000000:eec00000)
Enabling unmasked SIMD FPU exception support... done.
virtual kernel memory layout:
SELinux: Starting in permissive mode
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
Linux Plug and Play Support v0.97 (c) Adam Belay
PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report
pnp: 00:02: ioport range 0x4000-0x407f could not be reserved
pnp: 00:02: ioport range 0x5000-0x500f has been reserved
PCI: Bypassing VIA 8237 APIC De-Assert Message
Linux agpgart interface v0.101 (c) Dave Jones
agpgart: Detected VIA KT400/KT400A/KT600 chipset
agpgart: AGP aperture is 64M @ 0xe4000000
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
serio: i8042 KBD port at 0x60,0x64 irq 1
serio: i8042 AUX port at 0x60,0x64 irq 12
powernow-k8: Processor cpuid 681 not supported
Using IPI No-Shortcut mode
ACPI: (supports S0 S1 S4 S5)
hub 1-0:1.0: 2 ports detected
hub 2-0:1.0: 2 ports detected
hub 3-0:1.0: 2 ports detected
hub 4-0:1.0: 2 ports detected
ehci_hcd 0000:00:10.4: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
hub 5-0:1.0: 8 ports detected
ATA: abnormal status 0x7F on port 0xE207
kjournald starting. Commit interval 5 seconds
eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1.
Loading module: rt61pci - CVS (N/A) by http://rt2x00.serialmonkey.com.
rt61pci->rt61pci_init_firmware_cont: Error - Failed to load Firmware.
parport: PnPBIOS parport detected.
parport0: PC-style at 0x378, irq 7 [PCSPP,TRISTATE]
lp0: using parport0 (interrupt-driven).
agpgart: Found an AGP 3.5 compliant device at 0000:00:00.0.
agpgart: Putting AGP V3 device at 0000:00:00.0 into 8x mode
agpgart: Putting AGP V3 device at 0000:01:00.0 into 8x mode
ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:70:E7:4B:89
inet adr:192.168.0.251 Bcast:192.168.0.255 Masque:255.255.255.0
adr inet6: fe80::250:70ff:fee7:4b89/64 Scope:Lien
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:14924 errors:0 dropped:0 overruns:0 frame:0
TX packets:13102 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:14153220 (13.4 MiB) TX bytes:1674382 (1.5 MiB)
Interruption:18 Adresse de base:0xe000
lo Link encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
adr inet6: ::1/128 Scope:Hôte
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2130 errors:0 dropped:0 overruns:0 frame:0
TX packets:2130 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:5425634 (5.1 MiB) TX bytes:5425634 (5.1 MiB)
ifconfig wlan0 up
SIOCSIFFLAGS: Aucun périphérique de ce type
iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 IEEE 802.11g Frequency:2.412 GHz
RTS thr:off Fragment thr=2346 B
wlan0 IEEE 802.11g ESSID:""
Mode:Master Frequency:2.412 GHz
RTS thr:off Fragment thr=2346 B
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
wmaster0 Interface doesn't support scanning : Operation not supported
wlan0 Interface doesn't support scanning : Network is down